beautypg.com

3 recalling a position (scan), 4 enabling the patrol (patrol), 5 enabling autopan function – Videotec NXPTZT User Manual

Page 63: 6 recalling a pattern (tour)

background image

Instruc

tions manual - English - EN

63

MNVCNXPTZT_1343_EN

11.3 Recalling a position (Scan)

Using the control device it is possible to recall a

previously saved Preset position (for additional

information refer to the manual of the device being

used).

11.4 Enabling the patrol (Patrol)

Using the control device it is possible to enable the

automatic patrol (for additional information refer to

the manual of the device being used). For further

information refer to the relative chapter (11.13

Special controls, page 65).
Disabling can be carried out by moving the joystick

or by recalling a different type of movement.
To configure the Patrol function refer to the related

chapter (9.1.6.6 Patrol Menu, page 42).

11.5 Enabling Autopan Function

Using the control device it is possible to enable the

Autopan. For further information, refer to the manual

of the keyboard in use. For further information refer

to the relative chapter (11.13 Special controls, page 

65).
Disabling can be carried out by moving the joystick

or by recalling a different type of movement.
To configure the Autopan function, refer to 9.1.6.7

Autopan Menu, page 42.

11.6 Recalling a pattern (Tour)

The Tour functioning mode allows the repetition of a

previously recorded route in a continuous manner.
The pan & tilt can store up to 3 Tours, each lasting no

more than 2 minutes.
To save a Tour, enter the special preset of the number

of Tour to be saved using the keyboard (11.13 Special

controls, page 65).
To simplify the recording of the Tour, the pan &

tilt automatically limits the speed of the Pan & Tilt

depending on the Zoom factor.
While the Tour is being recorded, the remaining

recording time is displayed, as shown in the figure.

ID: 1

------------------------

RECORDING TOUR MODE

Iris to stop 99%

------------------------


Pan : - 5.56

Tilt: +120.01

Zoom: 36.00x

Fig. 124

To interrupt recording, press the Iris Open or Iris Close

key.
To start the play-back of a Tour, enter the special

preset of the number of Tour to be displayed using

the keyboard (11.13 Special controls, page 65).

This manual is related to the following products: