Videotec NXPTZT - Manual (Page 64)

EN - English - I
nstruc
tions manual
64 MNVCNXPTZT_1343_EN
11.7 Recalling the Home position
Using the control device it is possible to recall a
previously saved Home (Scan n.1) position (for further
information refer to the manual of the control device
in use).
11.8 Enabling the wiper (Wiper)
Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To enable/disable the wiper refer to the manual of
the control device in use or to the relative table (11.13
Special controls, page 65).
If it is left on, the Wiper automatically
disables itself.
11.9 Enabling the washer
(Washer)
Do not operate the wipers when the outside
temperature is below 0°C or in the presence
of ice.
To activate refer to the manual of the control device
used or the relevant chapter (11.13 Special controls,
page 65).
Refer to the relative chapter for the configuration (
9.1.9 Washer Menu, page 45).
11.10 Reboot the device
Using the control device it is possible to reboot the
unit. For further information refer to the manual of
the control device in use or to the relative table For
further information refer to the relative chapter (11.13
Special controls, page 65).
11.11 Manual correction of a
preset focusing
Load the preset whose focus needs to be changed
using the Scan command. Change the focus using
the appropriate keys Focus Far/Focus Near without
changing the Pan/Tilt/Zoom position. Save the preset
using the appropriate Preset command.
The manual correction of the Preset works
only if the Daytime/Nigh-time Autofocus
fields are disabled (9.1.6.5 Preset Menu
(Utilities Configuration), page 41).
11.12 Web interface
For further information refer to the relative
chapter (9.3 Web interface, page 54).