Videotec NXPTZT - Manual (Page 16)

EN - English - I
nstruc
tions manual
16 MNVCNXPTZT_1343_EN
7 Assembling and installing
Before starting any operation, make sure
the power supply is disconnected.
The assembly and installation must be
performed only by skilled personnel.
At start up the system makes some
automatic calibration movements: do not
stand near the device when it is powered.
Videotec strongly recommend to test the device
configuration and performance in a office\laboratory
before putting it in the final installation site..
7.1 Installation
The product is equipped with a multicore
cable that allows connections to be made.
7.1.1 Range of use
The installation temperature range is -40°C to 60°C
(-40°F/140°F).
The device is operative from-40°C to 60°C
(-40°F/140°F).
7.1.2 Methods of installation
The system can be installed only in a standard or
inverted position (ceiling mount). When installed
for inverted operation, the camera orientation and
controller functions are reconfigured for normal
operation through the system’s software.
Hardware adjustment is not required for inverted
operation.
Fig. 11