Videotec NXPTZT - Manual (Page 39)

Instruc
tions manual - English - EN
39 MNVCNXPTZT_1343_EN
9.1.5.13 Advanced Setting Menu (Other)
1. Sharpness: Sets the sharpness value of the
image.
2. High Resolution: Enables the High Resolution
function. The output video signal has a higher
resolution.
3. Wide Dynamic: Enables the Wide Dynamic
function. It improves vision when some zones
within the frame are much brighter than others.
4. Stabilizer: Enables the electronic image
stabilization function.
5. Progressive Scan: Enables the Progressive Scan
function. Gives a more stable image when the
Pan & Tilt is connected to a video server.
6. Noise Reduction: Sets the noise reduction
level. Vary the parameter according to the
environmental conditions to obtain a higher
contrast image.
OTHER
------------------------
1 SHARPNESS : 6
2 HIGH RESOLUTION : N
3 WIDE DYNAMIC : OFF
4 STABILIZER : N
5 PROGRESSIVE SCAN: N
6 NOISE REDUCTION : 2
Fig. 60
9.1.6 Movement Menu
1. Configuration: Sets one of the default
configurations of the pan & tilt.
• Standard: Sets the standard movement
speed.
• Low Speed: Sets the Low Speed mode that
slows down all pan & tilt operating speeds.
• Wind Mode: Sets the movements speed
to adjust them to environments subject to
vibrations and/or windblasts.
• High Perf: Establishes that all the movements
are carried out at the maximum possible
speed.
• Custom: Signals that the user has manually
selected the movement speeds of the unit.
2. Offset Pan: The pan & tilt has a mechanically
defined 0° position. The Offset Pan function
allows the definition of a different 0° position
using software.
3. Manual Control: To access the submenus
operating the parameters associated with the
manual movements of the device.
4. Preset: To access the submenus used to to edit
Preset values.
5. Patrol: To access the submenus used to edit
Patrol values.
6. Autopan: To access the submenus used to edit
Autopan values.
7. Motions Recall: To access the submenu which
manages automatic load of the movements.
8. Advanced: Allows access to the advanced
settings submenu.
MOTION
------------------------
1>CONFIG. : STANDARD
2 OFFSET PAN: + 0.00
3 MANUAL CONTROL >
4 PRESET >
5 PATROL >
6 AUTOPAN >
7 MOTIONS RECALL >
8 ADVANCED >
Fig. 61