Videotec NXPTZT - Manual (Page 61)

Instruc
tions manual - English - EN
61 MNVCNXPTZT_1343_EN
9.3.14 Factory Default
To restore the factory settings relative to the network,
user access and camera configuration follow this
procedure:
• Switch off the unit.
• Connecting the reset kit to the encoder that must
be reset.
• Power the unit. Wait for 2 minutes.
• Keep the button pressed for 15 seconds.
• Switch off the unit.
• Remove the reset kit.
• Power the unit.
Fig. 120
10 Accessories
For further details on configuration and
use, refer to the relative manual.
10.1 Washer
The P&T can be equipped with an external pump that
supplies water for the glass to be cleaned.
To complete the installation of the washer use the kit
supplied.
Fig. 121
For further information refer to the
relative chapter (11.9 Enabling the washer
(Washer), page 64).