Red Lion C48C - Manual (Page 34)

Factory Settings
This parameter is used to reset all parameters to their
factory defaults. The Factory Settings Chart below shows
the settings for each programming parameter.
FACTORY SETTINGS CHART *
-28-
FAcSEt
no
Reset all programming parameters to their
Factory Settings.
YES
Do not reset parameters to Factory Settings. no
DESCRIPTION MODE
OUTPUTS 3 2 1
Ac Out ACCESS OUTPUT TIME VALUES -L-L-L
OutrES OUTPUT RESOLUTION 0.01SEC
OutPut OUTPUT 1 TIME 0.10
OutPut OUTPUT 2 TIME 0.10
OutPut OUTPUT 3 TIME 0.10
rEVOut -n-n-n
rEVAnu REVERSE ANNUNCIATOR LOGIC -n-n-n
OutP.uP OUTPUT POWER-UP STATE -f-f-f
USER INPUTS
USrIn1 USER INPUT 1 rSt. -L
USrIn2 USER INPUT 2 rSt. -L
USrInb USER INPUT B rSt. -L
USr F1 USER F1 KEY rSt. -L
CodE PROGRAMMING CODE VALUE 0
ScroLL SCROLL DISPLAY no
SErSEt SERIAL BAUD RATE & PARITY 96n
SErAdr SERIAL UNIT ADDRESS 0
SErAbr ABBREVIATE SERIAL MNEMONICS no
PrnOPt PRINT OPTIONS 3
PrnrSt PRINT & RESET COUNT VALUES no
PRESCALER OUTPUT MODEL ONLY
PScOAt PRESCALER OUTPUT PULSE AT 1 dig
PScLEn PRESCALER OUT PULSE LENGTH 1
no P1 TRACK P2 P1trAc
30 PRESET 3 VALUE PrESEt
20 PRESET 2 VALUE PrESEt
10 PRESET 1 VALUE PrESEt
-y-y-y ACCESS PRESET VALUES Ac PrS
PRESETS
1 COUNTER 2 OPERATING MODE OPEr 2
bAtch COUNTER 2 ASSIGNMENT C2 ASn
11 COUNTER (1) OPERATING MODE OPEr ( 1 )
C1-Ud COUNT MODE Cnt In
COUNTER
------ DECIMAL POINT POSITION dEc Pt
1.00000 PRESCALER VALUE PScALr
-L ACCESS PRESCALER VALUE Ac PSc
PRESCALER
AutoSc NUMERIC VALUE ENTRY METHOD EntrY
REVERSE RELAY/OUTPUT LOGIC
3 2 1
RS-485 SERIAL OPTION (DUAL PRESET/BATCH MODELS ONLY)