Vaisala viewLinc-4.1-M211518 - Manual (Page 24)

Chapter 1: Getting Started
12 © 2012 Vaisala Canada Inc
2
Insert the Digi driver CD into viewLinc Server.
3
The Digi Device Setup Wizard launches automatically.
Click
Next
.
4
Select the device that matches the MAC address from
the bottom of your Digi device. Click
Next.
Note:
If your device is on a different subnet from the
server, you will need to know the IP address of
the Digi device and launch the RealPort installer
on the Digi Driver CD.
Configuring RealPort and Installing Drivers
1
In the Configure Network Settings screen, enter an IP
address (provided by your IT department). Click
Next
two
times.
2
In the Configure RealPort Settings screen, select “Install
Digi RealPort on this computer”. Click
Next
.
3
Click
Next
again. The settings are saved.
4
Click
Finish
.
Repeat Installing Digi Drivers for each Digi device.
Method 3: Using USB Port
You can also connect Vaisala Veriteq devices directly to PCs
using a USB Port, as shown in Figure 3.
Figure 3: Overview of viewLinc system using USB port to connect devices