DAVIS GroWeather Console - Manual (Page 41)

Using the GroWeather
Page 34 GroWeather Manual
Selecting Units of Measure
To select the desired unit of measure, simply press UNITS while viewing any of
the rainfall displays (except AutoClear). As you press UNITS, the GroWeather
alternates between inches and millimeters. Rate of rainfall switches corre-
spondingly from inches per hour to millimeters per hour automatically.
S AMPLE U NITS OF M EASURE
Entering Total Rainfall
You may have previously recorded rainfall amounts which you want reflected
in the GroWeather’s total rainfall amounts. Use the procedure below to enter a
total rainfall amount.
1. Press RAIN as necessary to display total rainfall.
2. Use ENTER to set the correct barometric pressure.
See “Using the Enter Key” on page 17 for instructions on using ENTER.
3. When finished entering the total rainfall amount, press any function key to exit.
The GroWeather saves the total rainfall amount. The system will add any
further rainfall to this total, until you clear total rainfall.
High Rate of Rainfall
The GroWeather displays the high rate of rainfall along with the time and date
at which it occurred. For information on displaying and clearing highs and
lows, see “Highs and Lows” starting on page 45.
Clearing Daily and Total Rainfall
You may reset daily and/or total rainfall at any time to begin a new total.
1. Press RAIN as necessary to display either daily or total rainfall.
2. Press and hold down CLEAR until the rainfall total resets to zero.
T OTAL R AINFALL C LEARED