Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 603)

OmniSwitch Troubleshooting Guide September 2005 page -9
show tech-support layer3 ipx
Creates a log file of the output of several Internet Packet Exchange (IPX) protocol Command Line Inter-
face (CLI) commands.
show tech-support layer3 ipx
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• This command creates a file called tech_support_ipx.log in the /flash directory of the output produced
by the show ipx interface, show ipx default-route, show ipx route, show ipx servers, show ipx
filter, show ipx type-20-propagation, show ipx packet-extension, and show ipx timers CLI
commands.
• If an existing file called tech_support_ipx.log already exists then it will be overwritten when this
command is executed.
• See the OmniSwitch CLI Reference Guide for more information on show commands.
Examples
-> show tech-support layer3 ipx
.........
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support Creates a log file of the output of system-wide CLI commands.
show tech-support layer2 Creates a log file of the output of several Layer 2 CLI commands.
show tech-support layer3 Creates a log file of the output of several Layer 3 CLI commands.