Other cases – Alcatel Carrier Internetworking Solutions 6648 User Manual
Page 107
Troubleshooting Spanning Tree
Writing a PR for Spanning Tree
OmniSwitch Troubleshooting Guide
September 2005
page 4-27
Spanning Tree Unchanged When Port State Has Changed
If the show spanning tree CLI command still displays the same information while a port state has changed
then the problem could be due to a broken communication path between the CMM and NI. In this case do
the following (for both the CMM and NI):
•
Time-out trace of the socket handler (stpNISock_totraceprint or stpCMMSock_totraceprint).
•
Warning trace of the socket handler (stpNISock_warningprint or stpCMMSock_warningprint).
•
Event trace (stpni_traceprint and stpCMM_traceprint).
•
Board-up trace (stpNISock_boardupprint or stpCMMSock_boardupprint).
Other Cases
For analysis of Spanning Tree on an NI do the following:
•
Event trace (stpni_traceprint).
•
Dump the port trace (stpni_debugport).
•
Time-out trace of the socket handler (stpNISock_totraceprint or stpCMMSock_totraceprint).
•
Warning trace of the socket handler (stpNISock_warningprint or stpCMMSock_warningprint).
•
Inter-NI trace: (stpNISock_intraceprint).
•
Boards seen alive by the Socket Handler (stpNISock_boardupprint or
stpCMMSock_boardupprint).
For analysis of Spanning Tree on a CMM do the following:
•
Event trace (stpCMM_traceprint).
•
Time-out trace of the socket handler (stpNISock_totraceprint or stpCMMSock_totraceprint).
•
Warning trace of the socket handler (stpNISock_warningprint or stpCMMSock_warningprint).
•
Boards seen alive by the Socket Handler (stpNISock_boardupprint or
stpCMMSock_boardupprint).