Show tech-support, Command from – Alcatel Carrier Internetworking Solutions 6648 User Manual
Page 596
page -2
OmniSwitch Troubleshooting Guide
September 2005
show tech-support
Creates a log file of the output of several system-wide Command Line Interface (CLI) commands.
show tech-support
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
•
This command creates a file called tech_support.log in the /flash directory of the output produced by
the show hardware info, show chassis, show module long, show fan, show power, show
temperature, show system, show running-directory, show microcode certified, show microcode
working, show microcode loaded, debug ipc pools slot, show aaa authentication, show health,
show vlan, show spantree, show interfaces status, show ip interface, show ip config, and show ip
protocols CLI commands.
•
If an existing file called tech_support.log already exists then it will be overwritten when this
command is executed.
•
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
See
for more information on the debug ipc pools slot command.
Examples
-> show tech-support
....................
Release History
Release 5.1; command was introduced.
Related Commands
Creates a log file of the output of several Layer 2 CLI commands.
Creates a log file of the output of several Layer 3 CLI commands.