Show tech-support layer3 mroute – Alcatel Carrier Internetworking Solutions 6648 User Manual
Page 602
page -8
OmniSwitch Troubleshooting Guide
September 2005
show tech-support layer3 mroute
Creates a log file of the output of several multicast routing Command Line Interface (CLI) commands.
show tech-support layer3 pimsm
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 7700, 7800, 8800
Usage Guidelines
•
This command creates a file called tech_support_mroute.log in the /flash directory of the output
produced by the show ip mroute, show ip mroute interface, show ip mroute-nexthop, show ip
mroute-boundary, and show ip mroute debug CLI commands.
•
If an existing file called tech_support_mroute.log already exists then it will be overwritten when this
command is executed.
•
See the OmniSwitch CLI Reference Guide for more information on show commands.
•
See
for more information on debug commands.
Examples
-> show tech-support layer3 mroute
.....
Release History
Release 5.1; command was introduced.
Related Commands
Creates a log file of the output of system-wide CLI commands.
Creates a log file of the output of several Layer 2 CLI commands.
Creates a log file of the output of several Layer 3 CLI commands.