Alcatel Carrier Internetworking Solutions 6648 - Manual (Page 317)

Troubleshooting 802.1X Troubleshooting with the CLI
OmniSwitch Troubleshooting Guide September 2005 page 19-3
Authentication : enabled,
IP Router Port : none,
IPX Router Port : none,
6 Verify the status of the 802.1x port using the show 802.1x command. Read the OmniSwitch CLI Refer-
ence Guide to understand the explanation for each field.
Layer-2: show 802.1x 2/3
802.1x slot/port = 2/3
authenticator PAE state = AUTHENTICATED,
backend authenticator state = IDLE,
direction = both,
operational directions = both,
port-control = auto,
port status = Authorized,
quiet-period (seconds) = 60,
tx-period (seconds) = 30,
supp-timeout (seconds) = 30,
server-timeout (seconds) = 30,
max-req = 2,
re-authperiod (seconds) = 3600,
reauthentication = no
7 Check for the 802.1x port statistics. Read the OmniSwitch CLI Reference Guide to understand the
detail of each field.
Layer-2: show 802.1x statistic 2/3
802.1x slot/port = 2/3
EAPOL frames received = 28,
EAPOL frames transmitted = 38,
EAPOL start frames received = 8,
EAPOL logoff frames received = 0,
EAP Resp/Id frames received = 10,
EAP Response frames received = 10,
EAP Req/Id frames transmitted = 13,
EAP Req frames transmitted = 10,
Invalid EAPOL frames received = 0,
EAP length error frames received = 0,
Last EAPOL frame version = 1,
Last EAPOL frame source = 00:0f:1f:d5:54:95