HP Smart Update Manager - Manual (Page 75)

Description Nodes
Use root (super user) password to start a session, and
inventory and update components when the credentials /su_password
specified in /username and /passwd do not have root
privileges to update components.
/su_password cannot be used with /use_sudo access
level.
NOTE: Specifying /targettype linux reduces
inventory time for deployments. This is an optional
command line argument.
Specifies that username and passwd are sudo user
credentials. /use_sudo
When you specify /use_sudo in the CLI along with
username
and passwd, then username and passwd
are considered as sudo credentials.
/use_sudo cannot be used with /su_username and
/su_password access level.
NOTE: Specifying /targettype linux reduces
inventory time for deployments. This is an optional
command line argument.
This is the IP address or the DNS name of a remote host,
which can be a remote server, remote iLO NIC port, Virtual /target “netAddress”
Connect Ethernet or Fibre Channel Module for c-Class
BladeSystem, or BladeSystem OA.
When two OAs are in an enclosure, this argument should
be the active OA. When specifying the IP address, use
either the IPv4 or IPv6 format.
Reduces inventory time for scripted deployments. This is
an optional command line argument. /targettype “type”
The following are valid node types:
•
Server
•
Windows
•
Linux
•
HPUX
•
EVA or Command View for EVA
•
FC Switch or Fibre Channel Switch
•
OA or Onboard Administrator
•
SUPERDOME 2 or SUPERDOME2 or Superdome 2
Onboard Administrator
•
iLO
• iLOFederation
•
VC or Virtual Connect
•
HP SAS or HP SAS B/L Interconnect Switch
•
VMware or VMware Host
•
iPDU or Intelligent Power Distribution
Unit (iPDU)
Use /targettype with /target parameter. You can
interchange the sequence of /targettype and /target.
If the node name includes spaces, make sure you enclose
the name in quotation marks, “ “.
NOTE: /targettype is an optional command line
argument. Use /targettype and /target together.
Command-line interface 75