Setting the idle timeout, Setting the link speed – HP Color LaserJet 5500 Printer series User Manual
Page 60
Setting the idle timeout
1. Press
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to select CONFIG METHOD.
10. Press
to select CONFIG METHOD.
11. Press
to highlight MANUAL.
12. Press
to select MANUAL.
13. Press
to highlight MANUAL SETTINGS.
14. Press
to select MANUAL SETTINGS.
15. Press
to highlight IDLE TIMEOUT.
16. Press
to select IDLE TIMEOUT.
17. Press the
or
arrow to to increase or decrease the number of seconds for the idle
timeout.
18. Press
to save the idle timeout.
19. Press the
P
AUSE
/R
ESUME
button to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O SUBMENU.
5. Press
to select I/O SUBMENU.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight LINK SPEED.
9. Press
to select LINK SPEED.
10. Press
to highlight the desired link speed.
11. Press
to select the desired link speed.
12. Press the
P
AUSE
/R
ESUME
button to return to the Ready state.
50
Chapter 3 I/O Configuration
EN_WW