HP Color LaserJet 5500 Printer series - Manual (Page 56)

Network configuration
You might need to configure certain network parameters on the printer. You can configure
these parameters from the printer control panel, the embedded Web server, or for most
networks, from the HP Web Jetadmin software (or the HP LaserJet Utility for Macintosh).
Note For more information about using the embedded Web server, see Using
the embedded Web server .
For a complete list of supported networks and for instructions on configuring network
parameters from software, see the HP Jetdirect Print Server Administrator’s Guide. The guide
comes with printers in which an HP Jetdirect print server is installed.
This section contains the following instructions for configuring network parameters from
the printer control panel:
•
configuring TCP/IP parameters
•
disabling unused network protocols
Configuring TCP/IP parameters
You can use the printer control panel to configure the following TCP/IP parameters:
•
usage of the BOOTP file for configuration parameters (the default is to use the BOOTP
file)
•
IP address (4 bytes)
•
subnet mask (4 bytes)
•
default gateway (4 bytes)
•
idle TCP/IP connection timeout (in seconds)
Configuring TCP/IP parameters using BOOTP or DHCP
1. Press to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press to select EIO X.
8. Press to highlight TCP/IP.
9. Press to select CONFIG METHOD.
10. Press to select CONFIG METHOD.
11. Press to highlight BOOTP or DHCP.
12. Press to save the setting.
13. Press the P AUSE /R ESUME button to return to the Ready state.
46 Chapter 3 I/O Configuration EN_WW