HP Color LaserJet 5500 Printer series - Manual (Page 127)

Control panel message Description Recommended action
CPR SENSOR
OUT OF RANGE A color plane registration (CPR) error
was detected during calibration. 1. Force a calibration by selecting Calibrate
Now from from the Print Quality menu.
2. If the message persists, contact
HP Support.
DATA RECEIVED
To print last page
press The printer received data and is
waiting for a form feed. When the
printer receives another file, the
message should disappear. Press to continue.
Deleting...
The printer is currently deleting the
stored job. No action necessary.
DISK DEVICE
FAILURE
alternates with
Ready
For menus press A device failure has occurred on the
specified drive. 1. Printing may continue for jobs that do not
require access to the disk drive.
2. To clear the message, turn the printer off
and then back on.
3. If the message persists, remove and
re-install the EIO disk drive.
4. If the message persists, replace the EIO
disk drive.
DISK FILE
OPERATION FAILED
alternates with
Ready
For menus press The printer received a PJL file
system command that attempted to
perform an illogical operation (for
example, to download a file to a
non-existent directory). 1. Printing may continue.
2. Turn the printer off and then back on.
3. If the message reappears, there may be a
problem with the software application.
DISK FILE
SYSTEM IS FULL
alternates with
Ready
For menus press The printer received a PJL file
system command that attempted to
store something on the file system
but was unsuccessful because the
file system is full. 1. Use the HP Web Jetadmin software to
delete files from the EIO disk drive and try
again.
2. To remove this message from the display,
turn the printer off and then back on.
DISK IS
WRITE PROTECTED
alternates with
Ready
For menus press The file system device is protected
and no new files can be written to it. 1. To enable writing to the disk, turn off write
protection, using HP Web Jetadmin.
2. To remove this message from the display,
turn the printer off and then back on.
Doors open.
Test aborted. A printer door has been opened
during a test. The test has been
aborted. Close the door and restart the test.
EIO DISK X
initializing The EIO disk device in slot X is
initializing. No action necessary.
EIO DISK X
NOT FUNCTIONAL
For help press The EIO disk in slot X is not working
correctly. Remove the EIO disk from the slot indicated
and replace with a new EIO disk drive.
EIO DISK X
spinning up The EIO disk device in slot X is
spinning up its platter. No action necessary.
EN_WW Control panel messages 117