Auto continue, To set the auto continue, Supplies low – HP Color LaserJet 5500 Printer series User Manual
Page 51: To set supplies low reporting, 41 supplies low
Auto continue
You can determine printer behavior when the system generates an Auto Continuable error.
ON is the default setting.
•
ON displays an error message for ten seconds before automatically continuing to print.
•
OFF pauses printing any time the printer displays an error message and until you press .
To set the auto continue
1. Press
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight AUTO CONTINUE.
7. Press
to select AUTO CONTINUE.
8. Press
or
to select the appropriate setting.
9. Press
to set the selection.
10. Press
P
AUSE
/R
ESUME
.
Supplies low
The printer allows two options for reporting that supplies are low; CONTINUE is the default
value.
•
CONTINUE allows the printer to continue printing while displaying a warning until the
supply is replaced.
•
STOP causes the printer to pause printing until you replace the used supply or press ,
which allows the printer to print while continuing to display the warning.
To set supplies low reporting
1. Press
to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight SUPPLIES LOW.
7. Press
to select SUPPLIES LOW.
8. Press
or
to select the appropriate setting.
9. Press
to set the selection.
10. Press
P
AUSE
/R
ESUME
.
EN_WW
Changing printer control panel configuration settings
41