HP Integrity rx4610 Server - Manual (Page 68)

Chapter 7: Installing Accessory Boards
61
Refer to Chapter 1, "Controls, Ports, and Indicators."
WARNING The power supply will continue to provide standby current to the HP Server until
the power cable is disconnected.
2. Disconnect the power cables and any external cables connected to the HP Server. If necessary,
label each one to expedite re-assembly.
WARNING Make sure that the rack is anchored securely, so it will not tip when the server
chassis is extended.
3. Pull the chassis out of the rack.
CAUTION Wear a wrist-strap and use a static-dissipating work surface connected to the
chassis when handling components. Ensure the metal of the wrist-strap contacts
your skin.
4. Loosen the two thumbscrews in the back of the chassis that secure the rear cover.
Refer to Chapter 2, "Opening and Closing the HP Server."
5. Read the documentation included with the accessory board and follow any special instructions.
6. Identify the accessory slot number to be used. See Figure 7-3.
PCI Hot Plug Slots
Non PCI Hot Plug Slots
Figure 7-3. Accessory Slots
NOTE Refer to the Readme file for the Tested Products List that shows specific slot
recommendations for a particular PCI board type.