HP Integrity rx4610 Server - Manual (Page 64)

Chapter 7: Installing Accessory Boards
57
7 Installing Accessory Boards
Introduction
The HP Server has ten I/O expansion slots available. PCI slots P1-P2 are 64-bit/33 MHz non-Hot
Plug I/O expansion slots. PCI slots P3-P10 are 64-bit/66 MHz PCI Hot Plug I/O expansion slots . The
PCI expansion slots are contained in four PCI segments:
• F16, 0 provides for PCI slots 1 and 2, video, and the PXB that controls the Super I/O
functions.
• F16, 1 provides for PCI slots 3 through 5 and the dual-channel LVDS controller.
• F16, 2 provides for slots 6 through 8.
• F16, 3 provides for slots 9 and 10.
Tested PCI Boards
For a list of tested PCI boards, check for compatibility in the Hardware Tested Products list for the HP
Server under the Service and Support topic for the specific NOS used in the HP Server at HP’s web
site:
http://www.hp.com/
CAUTION Some accessory board outputs may exceed U.S. National Electrical code (NFPA
70) Class 2 or limited power source limits and must use appropriate
interconnecting cabling in accordance with the National Electrical Code. (All
Hewlett-Packard boards comply with Class 2.)
Also refer to the Readme file and Chapter 10, "Configuring the HP Server," for instructions.
Tools Required
The tools used to remove or add accessory boards in the HP Server include:
• Phillips screwdriver (cross-head with #2 bit)
• Jumper removal tool or needle-nosed pliers
• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit includes a static-
dissipating work surface, a chassis clip lead, and a wrist strap.
• Equipment log and pencil.
Accessory Board Installation Guidelines
The following sections provide the guidelines necessary to install the PCI accessory boards into the
HP Server.
IRQ Settings
The IRQ settings are automatically assigned and don't require user intervention. The HP Server uses
the Plug-and-Play feature of the PCI boards to correctly assign its resources automatically.