HP Integrity rx4610 Server - Manual (Page 186)

Appendix A: Specifications
179
Clearing the CMOS Register
Jumper block J7A1 controls whether settings stored in CMOS nonvolatile memory (NVRAM) are
retained during a system reset. By default, the system does not keep the default values in this register.
You can configure J7A1 to restore the system defaults.
B
1
J7A1 J7A1
A
1
Figure A-18. CMOS Register Clear Jumper
Jumper settings labeled:
A. Do Not Keep Default Values in the CMOS Register (Default Setting)
B. Clear the CMOS Register and Restore the System Default Values
Clearing System Password
Jumper block J7A1 controls whether a stored password is retained or cleared during a system reset.
By default, the system retains this password. To clear it you must configure jumper block J7A1.
B
1
J7A1 J7A1
A
1
Figure A-19. Password Clear Jumper