HP NonStop G-Series - Manual (Page 86)

Appendix C: OVNM Utilities 86
ALTROVNM
The ALTROVNM utility allows clients to change certain attributes within the OVNM environment.
To run the utility on the HP NonStop server, you need to switch to the volume.subvolume where OVNM is
installed. To use the utility, use the following command at the prompt:
Run ALTROVNM
$DATA05 OVNM 15> run altrovnm
Getting current values...
--------------------
OVNM ALTER UTILITY
--------------------
1. Change the OVNM license key : XXXXXXXXXXXXXXXXXXXX
2. Change the Console License key : null^value
3. Change the TCP IP process name : $ZTC0
4. Change the OCC Port : 7370
5. Change the OVNM Port : 7350
6. Change the Home Terminal : $ITS
7. Change the Process Prefix : GA
8. Change the FileSys Option : NO
9. Change the Page Active Flag : No
10. Change the Mail Active Flag : NO
11. Change the Mail Gateway :
12. Change the Email Server IP address :
13. Change the Tandem Email IP address :
14. Change the Email Port Number :
15. Change the Email Sender ID :
16. Change the HighPin setting : ON
17. Change the AliveMsg Interval : 0 Mins
18. Change the Primary Priority : 160
19. Change the Primary CPU : 0
20. Change the Backup CPU : 1
21. Change the Application Collector : $0
22. Change the NSDB Location : $dummy.nsdb
23. Change the STAT Subvolume : $dummy.stat
24. Change the Process eEvents Only : NO
25. Change the MQDefaultPrefix param :
26. Change the MQEMSEvents param :
27. Change the MQMachIniFile param :
28. Add/alter Base24 NCP processes.
29. Change the Fault Tolerant Option : YES
30. NonStop Event Message Format : ENGLISH
Enter the number you wish to modify,
EXIT or QUIT (to cancel this request),