HP NonStop G-Series - Manual (Page 50)

Default Operations Manager (HPOM) Applications & Message Templates 50
5 Default Operations Manager (HPOM) Applications &
Message Templates
The default HPOM applications and message templates provided with OVNM are used to perform command &
control functions for critical events using the HPOM Management Console along with commands to start and stop
OVNM agents.
However, OVNM also provides the facility to control the monitoring of events as objects. The OVNM Object
Configuration Client (OCC) interface allows the user to configure objects & thresholds for monitoring. Depending
on the requirement, the user can configure OCC to forward only OCC defined events or allow all the events to
be passed to the HPOM Message Browser. For details refer to the OVNM Object Configuration Client Guide.
5-1 Default OVNM Applications
The applications provided with OVNM are grouped into the following two categories.
• NonStop Operator Tools
• OVNM Tools
These tools can be executed using the HPOM interface.
Figure 5-1 NonStop Tools Window
NOTE: The NonStop operator tools are provided as guidelines for operator tasks. These non-destructive
command templates can be used to design and develop user-defined tools on your HP Oparations
Management environment. The NonStop Operator tools use the NSCMD command processor to provide the
command & control capability for HP NonStop Servers. You can configure messages and actions that would
be triggered for each of these tools.
Refer to the section Configuring/Modifying NonStop Operator Tools in the OVNM Event Management Guide
for details.