HP NonStop G-Series - Manual (Page 73)

Appendix A: Manual Operations on HP NonStop Server 73
Manual OVNM Un-Installation
You can un-install OVNM from the HP NonStop host using the Delete HP NonStop Host option from the Host
Installation Client interface on the workstation. However, if the un-install process fails, then you can un-install
OVNM from the HP NonStop host manually. Follow the steps given below to perform a manual un-installation.
Switch to the subvolume where OVNM is installed and execute the following command at the TACL prompt to un-
install OVNM from the HP NonStop host.
Run DINSTALL / IN .INSTINFO /
Manually Starting OVNM on a HP NonStop Server
To start all the OVNM agents on the HP NonStop Servers, use the Start Agent button in the Host Management
Client.
To start various OVNM agents manually, switch to the volume.subvolume where OVNM has been installed and
execute the following command.
run strtovnm
Use the following command to start only the adapter (Enterprise Management/Console) component manually:
run strtovnm adapter
Use the following command to start only the client (Monitoring/$OVOCC) component manually:
run strtovnm client
Manually Testing Communication
To test the communication between HP NonStop Server and Operations Manager Management Server manually,
switch to the subvolume where OVNM has been installed and execute the following command.
Run genems ssid OVNM, event 999, coll $0, msg OVNM communication test was
successful
Check for the display of this message on the Operations Manager Management Server to test the connection
between the HP NonStop Server and the Operations Manager Management Server.
Manually Stopping OVNM on a HP NonStop Server
To stop all the OVNM agents on the HP NonStop Servers, use the Stop Agent button in the Host Management
Client window.
To stop various OVNM agents manually, switch to the volume.subvolume where OVNM has been installed and
execute the following command.
run stopovnm
Use the following command to stop only the adapter (Enterprise Management/Console) component manually:
run stopovnm adapter
Use the following command to stop only the client (Monitoring/$OVOCC) component manually:
run stopovnm client
Manually Stopping OVNM on Operations Manager Management Console in
Windows
To stop OVNM SPI Agent manually, use the following command at the command prompt:
net stop OVNM_SPI