HP NonStop G-Series - Manual (Page 81)

Appendix C: OVNM Utilities 81
Appendix C: OVNM Utilities
OVNM provides various utilities, which can be used either through the Host Management Client, or manually by
using the TACL macros. The information in this chapter explains the various utilities and how to use them
manually.
For details on how to run the OVNM utilities through a GUI, refer to the
Host Management Client topic.
INFOOVNM
The INFOOVNM TACL utility will gather the following information for OVNM:
• License Key
• TCP/IP process Name
• TCP/IP Port Number
• Various Process Names
• Filters
• Collectors
This TACL utility will gather the following information for OCC:
• License Key
• Maximum Clients
• TCP/IP Process Name
• TCP/IP Port Number
• Maximum Service Providers
• Various Process Names
• Filters
• Collectors
To run the utility on the HP NonStop server, you need to switch to the volume.subvolume where OVNM is
installed. To use the utility, use the following command at the prompt:
Run INFOOVNM
Running the utility generated the following output:
$DATA05 OVNM 11> run infoovnm
--------------------------
OVNM STATUS UTILITY
--------------------------
Data extracted from configuration in $DATA05.OVNM.
Report generated: September 29, 2009 14:16:33
License Key XXXXXXXXXXXXXXXXXXXX
MaxClients 50
TCP IP process $ZTC0
TCP IP port 7370
MaxServiceProviders 64
Main Process Name $OVOCC $DATA05.OVNM.ACC
Distributor Process Name $OVDAL $SYSTEM. SYS10.EMSDIST
Collector(s) $0
Filter(s) $DATA05.OVNM. PASSALL
Distributor Process Name $OVDA2 $SYSTEM.SYS10.EMSDIST
Collector(s) $ZLOG
Filter(s) $DATA05.OVNM.ZTSMFLTR
A
pp
en
di
x C