HP NonStop G-Series - Manual (Page 83)

Appendix C: OVNM Utilities 83
CLCTOVNM
CLCTOVNM is used to create specific information about the customer's environment, including their database.
To run the utility on the HP NonStop server, you need to switch to the volume.subvolume where OVNM is
installed. To use the utility, use the following command at the prompt:
Run CLCTOVNM
$DATA05 OVNM 12> run clctovnm
Purge $DATA05.OVNM.CLCTINFO
Have you been asked to capture the OVNM Database?
y
Looking for PAK...
Collecting OVNM configuration information...
This will take a few minutes....
scf /out \.$DATA05.OVNM.CLCTINFO/ assume process $ZTC0 ; status,detail
scf /out \.$DATA05.OVNM.CLCTINFO/ assume process $ZTC0 ; listopens,detail
System information collected. Now executing PAK.
This could take several minutes.
PAK / outv pak^out / $DATA05.OVNM.CLCTPAK, (OCCque, OCCquow, &
chabi, confhst, eevents, eventlog, evntrule, location, maildata, &
objhst,ormconf,ormobj, pagedata,devices), listall, open
-------------------------------------------------------------------
Please email $DATA05.OVNM.CLCTINFO (ASCII/TXT) and
$DATA05.OVNM.CLCTPAK (BINARY) to the person that requested this.
-------------------------------------------------------------------
HP NonStop OVNM Collect Complete.
If you do not want to capture the database while running CLCTOVNM then you get the following output.
$DATAO5 OVNM 19> run clctovnm
Purge $DATAO5.OVNM.CLCTINFO
Have you been asked to capture the OVNM Database?
n
Collecting OVNM configuration information...
This will take a few minutes....
scf /out $DATA05.OVNM.CLCTINFO/ assume process $ZTC0 ; status,detail
scf /out $DATA05.OVNM.CLCTINFO/ assume process $ZTC0 ; listopens,detail
-------------------------------------------------------------------
Please email $DATA05.OVNM.CLCTINFO (ASCII/TXT)
to the person that requested this.
-------------------------------------------------------------------
HP NonStop OVNM Collect Complete.
A
pp
en
di
x C