HP StorageWorks MSL6000 Tape Library - Manual (Page 34)

Installation 34
Figure 15 Securing the library
NOTE: Two-drive libraries require four retaining screws; four-drive libraries require two retaining
screws.
Converting a Rackmount Model to a Tabletop Model
Converting to a tabletop model requires a tabletop conversion kit and two people or a mechanical
lift to physically install the library into the tabletop base.
To make a two-drive library ready for tabletop use:
1. Position the tabletop base at the desired installation location.
2. Lift the library and place it on the base.
3. Place the top cover over the library and slide the locking tabs into the slots in the base.
4. Slide the cover forward into place.
5. Tighten the two thumb screws at the back of the library to lock the two parts together.
6. Tighten the four rack mount fasteners at the front of the library to secure it in the case.
1 Left Retaining Screw
2 Right Retaining Screw