HP StorageWorks MSL6000 Tape Library - Manual (Page 109)

MSL6000 series tape library user guide 109
20c0 Drive In Error
(Control failed to set SCSI ID.) • Press the Enter button to clear the
message.
• Ensure the drive shows good status
through the drive status window.
• Check SCSI ID settings.
• Cycle power to the library or reboot
using the GUI touch screen.
20c1 Drive In Error
(Control failed on installed drive.) • Press the Enter button to clear the
message.
• Ensure the drive shows good status
through the drive status window.
• Check SCSI ID settings.
• Check cabling.
• Cycle power to the library or reboot
using the GUI touch screen.
3000 Motor Fault Condition
(One of the robot motors has been
disabled and could not be re-enabled.)
• Press the Enter button to reboot.
• Cycle power to the library or reboot
using the GUI touch screen.
3002 Picker Tach Errors
(Picker tachometer errors were detected
when checking slots.)
• Press the Enter button to reboot.
• Cycle power to the library or reboot
using the GUI touch screen.
3005 Pass-thru Tach Errors
(Excessive Pass through elevator tach
errors.)
• Power down the library using the LCD
touch display.
• Remove Pass-through and check
connections.
3011 Bin Fetch Failure
(Loader failed to fetch a cartridge from a
bin.)
• Press the Enter button to reboot.
• Ensure cartridges are fully inserted in the
magazine(s).
• Ensure that there are no obstructions
inside the library (all cartridges are in
magazines).
• Run the cartridge cycle diagnostic to
verify.
• Check the tape cartridge used in the last
operation for damage.
Table 10 Fault Symptom Codes (continued)
FSC Message ERP