HP StorageWorks MSL6000 Tape Library - Manual (Page 131)

MSL6000 series tape library user guide 131
7021 SCSI response not matched to a known
command
(A command response was received from
a SCSI task, but the original command
opcode could not be determined.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
7022 Unexpected state after NonVolConfig
cmd
(After successfully completing a
NonVolConfigPut command, the current
state of the save operation was unknown.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
7023 Unexpected state after SCSI mode cmd
(After successfully completing a
SCSIUpdateMode Parameters command,
the current state of the save operation was
unknown.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
7024 Unexpected state after SCSI init cmd
(After successfully completing a
SCSIInitCommand, the current state of the
save operation was unknown.)
• Press the Enter button clear the
message.
• Cycle power to the library or reboot
using the GUI touch screen.
• Ensure the drive shows good status
through the drive status window.
7025 Message is Invalid Map Conversion
Parameters
(GUI Map Parameters are corrupt or
invalid.)
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
8001 Cartridge reject recovery failed • Press the Enter button to reboot.
• Ensure the drive shows good status
through the drive status window.
• Cycle power to the library or reboot
using the GUI touch screen.
• Check the tape cartridge used in the last
operation for damage.
Table 10 Fault Symptom Codes (continued)
FSC Message ERP