HP StorageWorks MSL6000 Tape Library - Manual (Page 31)

MSL6000 series tape library user guide 31
Figure 12 Library template (10000 rack enclosure shown)
NOTE: For HP rack system/e and AlphaServer H9A rack enclosures, refer to the appropriate rack
rail adapter kit.
2. Remove the template and then attach the rails using the supplied fasteners (see Figure 12 ). The
front rail brackets are threaded to directly accept screws. The rear brackets are not threaded and
require cage/clip nuts in the rack enclosure rear vertical rails.
NOTE: Refer to the Compaq Rack Products Reference Guide for detailed cage nut installation
instructions on 10000 racks.
NOTE: Fully tighten the front rail screws. Leave the rear rail screws “finger tight” to prevent binding
when mounting the library.
a. Fully extend the slide rails X on both sides of the rack enclosure until they lock.
b. Slide the inner guide rail Y as far as possible to the front of the rail assembly.