HP LaserJet 4300 Printer series - Manual (Page 95)

ENWW Replacing the stapler unit 93
6 Remove the new stapler unit from its packaging.
7 Connect the cable on the new stapler unit to the stapler/stacker.
8 Place the peg located on the bottom of the new stapler unit into the
hole in the stapler/stacker.
9 Press down on the tab at the top of the stapler unit and push the
unit into the stapler/stacker.
10 Rotate the stapler unit toward the rear of the printer until the unit
clicks into place.
11 If the stapler cartridge is not installed in the stapler unit, install it
now. (See “To load staples” on page 41 .)
6
7
8
9
10