HP LaserJet 4300 Printer series - Manual (Page 61)

ENWW Printing special paper 59
Printing transparencies
Use only transparencies recommended for use in laser printers. For transparency specifications,
see
“Transparencies” on page 190 .
At the printer control panel, open the Configure Device menu. On the Print Quality submenu,
select
FUSER MODES . Make sure that the fuser mode is set to TRANSPARENCY=LOW .
In the printer driver, set the paper type to Transparency.
At the printer control panel, open the Paper Handling menu. Set the tray type to
TRANSPARENCY for the tray that you are using.
CAUTION Failure to set the fuser mode to LOW can permanently damage the printer and fuser.
Load transparencies face up in tray 1 with the top toward the printer. Up to
50 transparencies can be loaded in tray 1.
A stack of up to 100 transparencies can be printed from tray 2 and the optional trays
(although stacking more than 50 at a time is not recommended). Because transparencies
are heavier than paper, do not load trays to maximum capacity. Load them with the side to
be printed facing down, and the top, short edge toward you.
To prevent transparencies from becoming too hot or sticking together, use the top output bin
and remove each transparency from the output bin before printing another.
Print only on one side of a transparency.
Place transparencies on a flat surface to cool after removing them from the printer.
If two or more transparencies feed at the same time, try fanning the stack.
Do not feed transparencies through the printer more than once.