Output setup submenu – HP LaserJet 4300 Printer series User Manual
Page 166
164 Appendix A Control panel menus
ENWW
Output Setup submenu
This submenu allows you to select settings for the optional stapler/stacker, if it is installed.
Some items on this menu are available in the program or printer driver (if the appropriate driver is
installed).
The section that follows lists the settings and possible values. In the Values column, the default
value for each setting is the one with an asterisk (*) next to it.
RAM DISK
OFF
*
AUTO
Determines how the RAM disk is configured. This item
appears only if there is no optional hard disk accessory
installed.
OFF
: The RAM disk is disabled.
AUTO
: Allows the printer to determine the optimal RAM-
disk size based on the amount of available memory.
Note
If you change the setting from
OFF
to
AUTO
, the printer
automatically reinitializes when it becomes idle.
LANGUAGE
*
ENGLISH
Several
Selects the language for the messages that appear on
the printer control panel display.
Item
Values
Explanation
Item
Values
Explanation
STAPLER/STACKER
There is no value to
select.
Configure behavior for the optional stapler/stacker.
STAPLES
*NONE
ONE
Determines whether print jobs are stapled or not.
NONE
: Turns off stapling.
ONE
: Turns on stapling.
Note
Selecting the stapler at the printer control panel
changes the default setting to staple. It is possible that
all print jobs will be stapled.
For information about selecting the stapler at the
printer control panel, see
STAPLES OUT
*STOP
CONTINUE
Determines how the printer behaves if the stapler runs
out of staples, as indicated by the
STAPLER OUT OF
STAPLES
message on the printer control panel display.
STOP
: The printer stops printing until you refill the
stapler.
CONTINUE
: The stapler accepts print jobs if it is out of
staples, but the pages will not be stapled.
For information about ordering a new staple cartridge,
see
“Ordering information” on page 17
. For information
about refilling the stapler, see
.