Loading envelopes in the optional envelope feeder – HP LaserJet 4300 Printer series User Manual
Page 58
56 2 Printing tasks
ENWW
Loading envelopes in the optional envelope
feeder
Use these steps to load envelopes in the optional envelope feeder.
To load envelopes in the optional envelope feeder
1
Fold down the envelope-feeder tray. Lift the envelope weight.
2
Squeeze the release lever that is located on the left envelope guide
and slide the guides apart.
3
Load envelopes with the front side facing up, and the postage-end
toward the printer. (Stack envelopes no higher than the arrows on
the guides.) Slides the envelopes into the printer as far as they will
go without forcing them. The envelopes at the bottom of the stack
should slide in slightly further than the envelopes at the top of the
stack.
4
Adjust the guides to touch the envelopes without bending them.
5
Lower the envelope weight onto the envelopes.
6
To reduce curl and jams, open the rear output bin to use the
straight-through paper path. (See
“Printing to the rear output bin” on
Note
Select the envelope size in one of these locations, trying them in this
order: in the program, in the printer driver, or on the Paper Handling
menu at the printer control panel. (See
1
2
3
4
5