HP H-series Enterprise Fabric Management Suite Software - Manual (Page 111)

HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Enterprise Fabric Management Suite User Guide 111
Modifying an SNMP v3 user
To modify an SNMP v3 user:
1. Select the entry switch in the fabric tree.
2. Select Switch > SNMP > SNMP v3 Manager to open the SNMP v3 Manager dialog box ( Figure 61 ).
3. Select a user in the user list, and select Edit > Edit User to open the SNMP v3 User dialog box.
4. Modify the entries as needed, and click OK. For information about the entry fields, see Table 20 .
5. Click OK to save the settings and close the SNMP v3 User Editor dialog box.
6. In the SNMP v3 Manager dialog box, click OK to save and activate the SNMP v3 security
configuration.
Removing an SNMP v3 user
To remove an SNMP v3 user:
1. Select the entry switch in the fabric tree.
2. Select Switch > SNMP > SNMP v3 Manager to open the SNMP v3 Manager dialog box ( Figure 61 ).
3. Select a user in the user list, and select Edit > Remove User.
4. Click Yes to remove the user; click Cancel to cancel the removal.
5. Click OK to save the settings and close the SNMP v3 User Editor dialog box.
6. In the SNMP v3 Manager dialog box, click OK to save and activate the SNMP v3 security
configuration.
Configuring Call Home
The Call Home feature enables you to configure switches to send alerts and events to pagers and email.
You can configure the types of events to cover and where to send the alerts using the Call Home Setup
dialog box ( Figure 63 ). To open the Call Home Setup dialog box:
1. Select a switch in the fabric tree.
2. Select Switch > Call Home > Setup.
IMPORTANT: The Call Home feature provides an email notification capability for the switch. This service
is not related to the HP Call Home feature, which notifies HP services.
Figure 63 Call Home Setup dialog box
Table 21 describes the fields of the Call Home Setup dialog box.