HP H-series Enterprise Fabric Management Suite Software - Manual (Page 101)

HP StorageWorks 8/20q and SN6000 Fibre Channel Switch Enterprise Fabric Management Suite User Guide 101
Table 14 Network Properties dialog box—IP fields
Field Description
IPv4 Network Enable this option to permit the IPv4 addressing format to be used anytime you
are required to enter an IP address.
CAUTION: Disabling this option prevents you from using an IPv4 IP
address for system services.
IPv6 Network Enable this option to permit the IPv6 addressing format to be used anytime you
are required to enter an IP address.
CAUTION: Disabling this option prevents you from using an IPv6 IP
address for system services.
Network Discovery Choose one of the following methods for assigning the IP address:
• Static—Uses the IP configuration parameters entered in the Network
Properties dialog box.
• BootP—Acquires the IP configuration from a BootP server. If no IP address is
obtained, the switch reverts to the previously configured IP address.
• RARP (Reverse Address Resolution Protocol)—Acquires the IP address from a
RARP server. A RARP request is broadcast with up to three retries, each at 5
second intervals. If no IP address is obtained, the switch reverts to the
previously configured IP address.
• DHCP (Dynamic Host Configuration Protocol)—Acquires the IP configuration
from a DHCP server. If no satisfactory lease is obtained, the DHCP client
attempts to use the previously configured lease. If the previous lease cannot
be used, no IP address is assigned to this switch to avoid an IP address
conflict.
IP Address Enter the Internet Protocol address for the Ethernet port. The default value is
10.0.0.1.
Subnet Mask Enter the subnet mask address for the Ethernet port. The default value is
255.0.0.0.
Gateway Enter the IPv4 gateway address.
Discovery Choose one of the following methods for assigning the IP address:
• Static—Uses the IP configuration parameters entered in the Network
Properties dialog box
• DHCPv6 (Dynamic Host Configuration Protocol version 6)—Acquires the IP
configuration from a DHCP server. If no satisfactory lease is obtained, the
DHCP client attempts to use the previously configured lease. If the previous
lease cannot be used, no IP address is assigned to this switch to avoid an IP
address conflict.
• NDP (Neighbor Discovery Protocol)—Part of the Stateless Address Auto
configuration protocol. It replaces the Address Resolution Protocol used with
IPv4.
Config IPv6 Address Enter the IPv6 address for the Ethernet port.
Gateway Enter the IPv6 gateway address.