HP 3PAR Application Software Suite for Microsoft Exchange - Manual (Page 70)

HpRmCli Exch create
SYNTAX
(For Exchange 2010/ Exchange 2013) HpRmCli Exch create <-s
ExchangeServer> <-vs verification_server> <-mdb mailbox Database>
[-domain domain name][[-nc [-truncate]] [[-rc [-defer]]
[-exp n ] [-retain n] [-f]][-noemail][-level log|Full]
(For Exchange 2007) HpRmCli Exch create <-s ExchangeServer> <-g
StorageGroup> [-domain domain name] [-active|-passive|-both] [-lcr]
[-nc [-truncate]] [<-rc TargetServer> [-defer]] [-exp n]
[-retain n[-f]] [-noemail]
DESCRIPTION
The HpRmCli Exch create command creates a virtual copy of a mailbox database (or storage
group for Exchange 2007) on the primary host where Exchange is running.
By default, HP 3PAR Recovery Manager for Exchange exposes the virtual copy to the backup host
during virtual copy creation for data-integrity checking. Also by default, the Exchange transaction
log is truncated after the virtual copy validates successfully.
This command only supports online backup of an entire mailbox database/storage group. Therefore,
you must make sure the mailbox database/storage group is online before creating a virtual copy.
PARAMETERS
The following options are supported:
•
<-s ExchangeServer> - The name of the Exchange server.
•
(For Exchange 2010/ Exchange 2013)<-mdb mailbox Database> - The name of the
mailbox database for which virtual copy is to be created.
•
(For Exchange 2007)<-g StorageGroup> - The name of the storage group for which virtual
copy is to be created. This parameter is case sensitive.
•
(For Exchange 2010/ Exchange 2013) <-vs verfication_server> - The server on
which snapshot verification is to be performed. This cannot be used with the -nc option.
NOTE: The verification can not be performed on the target server in case of remote copy
creation.
•
-nc - Optional. Skip the integrity check. Not recommended. This cannot be used with the
-vs option.
•
-truncate - Optional. Force truncation of log upon successful VC creation when -nc is
used.
•
(For Exchange 2010/ Exchange 2013) <-rc TargetServer> - Optional. Indicates that
the virtual copy creation is for Remote Copy. Specify the target server on which to create the
virtual copy once Remote Copy completes.
•
-defer - Optional. Defer the log truncation decision after the Remote Copy completes. This
cannot be used with the -nc or -truncate options.
•
-noemail - Optional. Do not send an email notification even if configured for this operation.
70 Using the Recovery Manager CLI