Setting up the symantec backup exec, Using your backup software – HP 3PAR Application Software Suite for Microsoft Exchange User Manual
Page 37
Figure 10 HP 3PAR Recovery Manager for Exchange User Account Properties
e.
Click Apply and then select OK. You must restart the service when asked for.
NOTE:
These changes must be done on all the servers wherever the HP 3PAR Recovery
Manager for Exchange is running.
Setting Up the Symantec Backup Exec
To use Symantec Backup Exec with Recovery Manager, either remote administrator console or
typical setup (that is media server, administrator console) must be installed on HP 3PAR Recovery
Manager for Exchange backup server. Device must be configured in Backup Exec for backup.
1.
Open Symantec Backup Exec administrator console.
2.
From the tool bar, select the device you want to backup.
3.
To configure the device for backup, follow the onscreen instructions.
Using Your Backup Software
•
The default mount point for virtual copy backups is:
•
You must manually synchronize backups. If a backup expires in your backup software, you
must manually remove the backup from Recovery Manager. If you remove a valid backup
from Recovery Manager, you must manually remove it from your backup software.
•
Recovery Manager does not track restore progress. You must use your backup software to
monitor restore progress.
Using Your Backup Software
37