HP 3PAR Application Software Suite for Microsoft Exchange - Manual (Page 20)

2 Installing and Uninstalling HP 3PAR Recovery Manager
for Microsoft Exchange
Requirements for Configuring an Administrator Account
Before proceeding with the installation or performing any administrative operations, ensure the
following user privileges for Administrator meet the following requirements:
•
Exchange permissions must be assigned to a user account through Microsoft Exchange
•
Domain accounts must be present in the local administrator's group to install and to run
Recovery Manager
•
Apply a role of greater than read only administrator to the Windows domain account running
Recovery Manager Software for Microsoft Exchange
Upgrading to HP 3PAR Recovery Manager for Exchange
This section provides instructions for upgrading HP 3PAR Recovery Manager Software for Microsoft
Exchange from version 4.2.0, 4.3.0, 4.4.0, or 4.4.1 to version 4.4.2.
Upgrading from Recovery Manager 4.4.0 for Exchange or Recovery Manager 4.4.1
for Exchange to Recovery Manager 4.4.2 for Exchange
You can upgrade to HP 3PAR Recovery Manager 4.4.2 Software for Microsoft Exchange Server
from Recovery Manager 4.4.0 for Exchange or Recovery Manager 4.4.1 for Exchange. While
doing so, user is prompted for upgrade confirmation. Accepting to do so will uninstall the older
version and install Recovery Manager 4.4.2 for Exchange.
Upgrading from Recovery Manager 4.3.0 for Exchange to Recovery Manager 4.4.2
for Exchange
You can upgrade to HP 3PAR Recovery Manager 4.4.2 Software for Microsoft Exchange Server
from Recovery Manager 4.3.0 for Exchange. While doing so, user is prompted for upgrade
confirmation. Accepting to do so will uninstall the older version and install Recovery Manager
4.4.2 for Exchange.
Migration of Repository from HP 3PAR Recovery Manager for Exchange 4.3 to 4.4.2
The existing repositories of the Microsoft Exchange 2007 and 2010 are identified with StoreServ
ID which is modified to be identified with StoreServ Storage Serial Number in HP 3PAR Recovery
Manager for Exchange 4.4.2. This is to support the changes in HP 3PAR CLI 3.1.2.
•
The utility RMERepoUtils.exe is executed from the installer during upgrade.
•
Any operation on the virtual copies created with HP 3PAR Recovery Manager for Exchange
4.3 will fail, if the StoreServ corresponding to the virtual copy was not registered by the HP
3PAR VSS Provider during the upgrade. Hence, RMERepoUtils.exe utility must be
mandatorily executed explicitly after the StoreServ is registered. You can launch it directly
from the installed directory (goodies). For example:C:\Program Files\3par\RM\
Exchange\goodies\lib>RMERepoUtil.exe (No parameter is required)
NOTE: Follow the instructions of the setup.exe during upgrade to avoid loss of Recovery
Manager repository.
Upgrading from Recovery Manager 4.2.0 for Exchange to Recovery Manager 4.4.2
for Exchange
To migrate from version 4.2.0, remove the current version of HP 3PAR Recovery Manager for
Exchange. Install HP 3PAR Recovery Manager for Exchange 4.4.2 and move the Repository folder
20 Installing and Uninstalling HP 3PAR Recovery Manager for Microsoft Exchange