Canon PowerShot G1 X Mark II - Manual (Page 104)

104
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode / Hybrid
Auto Mode
Other Shooting
Modes
P Mode
Tv, Av, M, C1, and
C2 Mode
Playback Mode
Wi-Fi Functions
Setting Menu
Accessories
Appendix
Index
•
After you set the shutter speed or aperture value, the exposure level
may change if you adjust the zoom or recompose the shot.
• Screen brightness may change depending on your specified shutter
speed or aperture value. However, screen brightness remains the
same when the flash is up and the mode is set to [ h].
•
Exposure may not be as expected when the ISO speed is set
to [
], because the ISO speed is adjusted to ensure standard
exposure relative to your specified shutter speed and aperture
value.
•
AE lock is only available when the ISO speed setting is [ ].
•
[
D]: Manual
• Calculation of standard exposure is based on the specified metering method
(
=
79 ).
Still Images
Adjusting the Flash Output
Choose from the three flash levels in [ D] mode.
1
Enter [
D] mode.
z z
Set the mode dial to [
D].
2 Set the flash mode.
z z Press the <
n> button, choose [Flash
Control] on the [
4] tab, and then press
the <
m> button( =
26 ).
z z
Press the <
o>
buttons to choose
[Flash Mode], press the <
q> buttons
to choose [Manual], and then press the
<
n> button.
3 Configure the setting.
z z Raise the flash, press the < r> button and
immediately turn the < > ring to choose
the flash level, and then press the < m>
button.
z z Once the setting is complete, the flash
output level is displayed.
[
] low, [ ] medium, [ ] high