Canon VB-C60 - Manual (Page 95)

95
4
Register
Camera
Ser
ver
and
Set
Recor
ding
Sc
hedule
Register Camera Server
●
Select a Storage Server
Select a Storage Server from the
drop-down menu which lists pre-
configured Storage Servers and
enter the Host Name or IP
address in Host Name or IP and
Port number in Port.
The Host Name or IP must be
255 characters or less (each label,
separated by a period, must be 63
characters or less) and the Port
number must be a figure within the
range from 1 to 65535.
If you do not want the Camera Server to record video, select Do not record from
the drop-down menu of Storage Server.
2
1
●
Configure Recording Stream Usage (VB-C60)
VB-C60 has a video recording stream
function that temporarily saves images in
the camera memory as a function to
handle packets dropped due to network
interruptions, etc.
To use the recording streams, select
the Use the stream for recording
checkbox.
If you have a Multi-Terminal Module VB-EX50 unit plugged into a
VB-C50i/VB-C50iR, VB-C50FSi, VB-C50Fi and have configured the
“Use External Video Input”, video seen in the Viewer may be
taken from cameras connected to the Multi-Terminal Module.
Switch the video at the Admin Viewer as required.
Tip
Recording schedules should be set in order to record video.
There is a maximum number of 64 Camera Servers that can be
registered on one Storage Server with VK-64 (or 16 cameras
with Network Video Recorder VK-16).
If you are using the Viewer only, the Storage Server cannot be
configured.
If you have changed the Camera Server’s IP address, you also
need to change the host names in the Connection Settings
and Storage Server Settings dialogs.
Note
COP
Y