Canon VB-C60 - Manual (Page 268)

268
Messages Cause
An attempt was made to delete the
location for which a zone has been
added.
An attempt was made to add a zone
while the location has not been
registered.
An attempt was made to add a zone
with a name that has been already
registered.
An attempt was made to register a
zone without entering the name.
An attempt was made to delete the
zone for which a camera server has
been added.
Even though video of a camera
server is configured to be recorded in
the Storage Server, the IP address
and port used are the same as the
camera server that has been
configured in the Storage Server.
An attempt was made to add a
camera server without selecting a
location and zone.
An attempt was made to add a
camera server without selecting a
location and zone. This is displayed
when VB150 is in the “simultaneous”
mode and multiple cameras are
connected.
After deleting the camera server, an
attempt was made to add the camera
server again when the changes have
not been saved.
An attempt was made to connect with
an invalid host name/IP address.
An attempt was made to connect with
an invalid port number.
Delete the added zone before
deleting the location.
Select a location.
This zone name cannot be used
because it already exists.
The zone name is not specified.
Delete the added camera server
before deleting the zone.
The recording settings of this
camera server have already been
configured in the selected Storage
Server. Check the settings and try
again.
Select a location and zone.
Select a location and zone. ‘Camera
number’
The camera server with the same
host name and port number is being
deleted. Save the changes and add
the server again.
The host name specified in
“Connection Settings” is invalid.
Check the host name or IP address.
The port number specified in
“Connection Settings” is invalid.
Specify a number within the range
of 1 and 65535.
Adding/Editing a
Location and
Zone
Adding a
Camera Server
Messages List
COP
Y