Canon VB-C60 - Manual (Page 127)

127
4
Register
Camera
Ser
ver
and
Set
Recor
ding
Sc
hedule
Set Motion Detection Recording
The Motion Detection Options field also allows you to set the sensitivity for Motion
Detection within the Active Region. Sensitivity and Area Ratio are set by using the two
sliding bars.
Motion detection status can be confirmed by the Detection Indicator during operation.
Detection Indicator Colors
Motion is displayed in the Detection Indicator as a green color bar and will remain green if the
level of motion is below the configured Sensitivity and within a defined Area Ratio. If motion
reaches the set Sensitivity and Area Ratio, the color bar changes to yellow and if the
detected motion remains at the yellow level for the specified duration period, a red color bar is
displayed and an event is triggered. The behavior of the Detection Indicator is described as
follows.
Green color bar - Changed area is less than the specified Area
Ratio, i.e., activity remains at the left of the Area Ratio marker.
Area Ratio marker.
Area Ratio slide bar.
Area Ratio marker.
●
Step 3: Set the active region for recording
In the Active Region field, adjust the region where
motion detection is triggered. By default, the
Active Region is the full area. In addition you
cannot use pan, tilt, and zoom operations in this
window.
Click one of the corner or edge handles and
hold down the mouse button.
Drag the handle to change the motion-
trigger boundary (dotted frame).
2
1
COP
Y