Hole sewing mode – Brother PE-DESIGN Ver.432 User Manual
Page 78
69
The
Sewing Attribute Setting
dialog for the selected stitch displays.
Hole Sewing Mode
The hole sewing mode is used to avoid sewing overlapping areas twice. It can be set only when one of
the overlapping areas is completely enclosed in another area.
1
Click
on the Tool Box.
The shape of the cursor changes to
and is displayed together with a small figure of the Tool
Box button.
2
Click on the enclosing part of a pattern comprised of a region completely enclosed into another
one.
3
This dialog will display.
◆
If necessary, change the settings.
See “Sewing Attributes” on page 85.
•
To restore the default value of a set-
ting after changing it, click the
Default
button at the left of that setting.
◆
To apply the new settings to single
lines, click the lines you want to apply
the settings to with the left button.
◆
Click
Close
to remove the dialog from
the screen.
◆
Click on the central region to toggle hole sew-
ing on/off.
◆
Click
OK
to set hole sewing.
◆
Click
Cancel
to exit without setting hole sewing.