Brother DCP 9040CN - Manual (Page 180)

Scanning
172
9
Using the Scan key (For USB cable users)
9
Note
If you use the Scan key on a network, see Using the Scan key on page 202.
You can use the (Scan) key on the control panel to scan documents directly into your word
processing, graphics or E-mail applications or to a folder on your Macintosh
®
.
Before you can use the (Scan) key on the control panel, you have to install the Brother MFL-Pro
Software Suite and connect the machine to your Macintosh
®
. If you installed the MFL-Pro Suite from the
included CD-ROM, then the correct drivers and ControlCenter2 are installed. Scanning by the (Scan)
key follows the configuration on the Device Button tab. (See SCAN on page 185.) For details about how to
configure the ControlCenter2 buttons to launch the application of your choice using the
(Scan) key,
see Using ControlCenter2 on page 184.
Note
• If you want to scan a document using the duplex scanning feature, you need to put the document in the
ADF and then choose 2sided (L)edge or 2sided (S)edge depending on your document layout.
• Choose your document layout from following table:
Document Layout Table
• Duplex scan is supported by the MFC-9840CDW and DCP-9045CDN only.
• Duplex scan is available from the ADF only.
• Duplex scan is not available for legal size paper.
Portrait Landscape LCD Message
Front Back Front Back
(L)edge
(Long edge)
Front Back Front Back
(S)edge
(Short edge)