Brother DCP 9040CN - Manual (Page 175)

Scanning
167
9
Scanning an image into your Macintosh
®
9
You can scan a whole page, or scan a portion after pre-scanning the document.
Scanning a whole page
9
a
Put the document face up in the ADF, or face down on the scanner glass.
b Adjust the following settings, if needed, in the Scanner Setup dialog box:
„ Resolution
„ Scan Type
„ Document Size
„ Brightness
„ Contrast
c
Click Start.
When scanning has finished, the image appears in your graphics application.
Scanning a duplex document (MFC-9840CDW and DCP-9045CDN only)
9
a
Put the document face up in the ADF.
b
Check Duplex (Two-sided) Scanning and choose Long-edge binding or Short-edge binding.
c
Adjust the following settings, if needed, in the Scanner Setup dialog box:
„ Resolution
„ Scan Type
„ Document Size
„ Brightness
„ Contrast
d Click Start.
Note
• You cannot adjust the scanning area.
• Duplex scan is not available for legal size paper.
• Duplex scan is available from the ADF only.