Live and recording settings mpeg cameras – Milestone M50 User Manual

Page 47

Milestone Husky M30/M50

Administrator's Manual

www.milestonesys.com

Getting started

Name

Description

Frame Rate

Required average frame rate for video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour).

Live Frame Rate

Required average frame rate for live video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour).

If the camera supports dual stream and dual stream is enabled, the
Live Frame Rate column will be read-only with the value Dual
streaming

—which cannot be altered.

Recording Frame Rate

Required average frame rate for recorded video from the camera.
Select number of frames, then select the time unit interval (second,
minute or hour). The frame rate must be higher than the frame rate
specified under normal mode.

Apply Template

Select which cameras you want to apply the template for. Use one
of the two Set buttons to actually apply the template.

Select All

Click button to select all cameras in the Apply Template column.

Clear All

Click button to clear all selections in the Apply Template column.

Apply template on selected
cameras

Apply the value from the template to selected cameras.

Live and recording settings MPEG cameras

This wizard page only appears if one or more of your cameras use the MPEG video format.

Specify which frame rate to use for each camera, and whether to record all frames or keyframes only.
You can also select pre- and post-recording, allowing you to store recordings from periods preceding
and following detected motion and/or specified events.

Note that all of the properties can also be specified individually for each camera.