Milestone M50 - Manual (Page 37)

Milestone Husky M30/M50 Administrator's Manual
www.milestonesys.com 37 Settings
Click Restore Default Settings below the behavior list to restore your system to its default behavior.
Default File Paths
Your system uses a number of default file paths:
File paths Description
Default recording path for new
cameras
All new cameras you add use this path by default for storing
recordings. If required, you can change individual cameras'
recording paths as part of their individual configuration (see
"Recording and archiving paths" on page 91), but you can also
change the default recording path so all new cameras you add use
a path of your choice.
Default archiving path for new
cameras
All new cameras you add use this path by default for archiving (see
"About archiving" on page 126). If required, you can change
individual cameras' archiving paths as part of their individual
configuration, but you can also change the default recording path so
all new cameras you add use a path of your choice. Note that
camera-specific archiving paths are not relevant if you use dynamic
path selection (on page 72) for archiving.
Configuration path The path by default used for storing your system configuration.
Analytics Event Settings
Analytics Event Settings let you specify the following:
Name Description
Enabled Lets you enable the analytics event feature
Port
Specify the port used by this service. Default port is 9090.
Make sure that relevant VCA tool providers also use this port
number. If you change the port number, make sure that VCA tool
providers change their port number accordingly.
All network addresses or
Specified network addresses
Specify whether events from all IP addresses/host names are
accepted, or only events from IP addresses/host names specified in
a list
—see the following.
In the Address list specify a list of trusted IP addresses/host names
that you want this service to recognize. The list is used to filter
incoming data so that only events from certain IP addresses/host
names are allowed. Both Domain Name System (DNS) and IPv4
address formats can be used in the list.
You have two ways of adding addresses to the list: either manually
or by importing an external list of addresses.
Manual entering: type the required IP address/host name in the
address list. Repeat for each required address.