Dwyer DLI User Manual
Page 52
52 |
P a g e
When the device has a feature such as password, alarm setting, thermocouple type, trigger settings,
wireless configuration and engineering units then a corresponding button will be displayed on the
screen. An
Alarm Settings button is displayed in the example below in the lower right hand portion
of the screen.
For some types of data loggers which have the pushed start button, the following window may
appear:
The device start time may be delayed after the start button of the data logger has been pushed. This
time will depend on the value of the delay start.
The reading rate can be selected to determine its data recording frequency. When selected, the
maximum recording time will be calculated for the particular device, based on its internal memory
capacity, and displayed in
Log Time box. Once started, the device will continue to record readings
until its memory is full, unless the feature of
Wrap Around is enabled. When full, the data recorder
will stop recording additional readings then place itself into a low power state to maximize battery
life. The data stored in the data logger is always preserved (even in the case of battery failure) unless
the device is reset or started. When re-started the existing readings are then overwritten.
For some types of data loggers which have the stop feature, the following window may appear: