Dwyer DLI User Manual
Page 100
100 |
P a g e
c. Notify on every reading out of range – will notify the user at the programmed sample
interval when an alarm condition has occurred.
d. Notify only on initial out of range reading – will notify the user as soon as the first alarm
condition occurred, but will not continue to alert the user thereafter.
e. Notify on every [H] [M] [S] while reading is out of range – will notify the user after a
specified length of time that an alarm condition has occurred. This is useful if a parameter is allowed
to stay in an alarm condition for a certain amount of time, and if the alarm continues, it is of concern
to be alerted.
f. Channel Settings – Allows the user to set the channel in which they want an alarm to be
associated with. The user can also specify the respective units for the measurement channel.
g. Low Alarm – allows the user to specify that if a value measured is lower than what the
user specified, then either a screen and/or email/text message alarm will appear.
h. High Alarm - allows the user to specify that if a value measured is higher than what the
user specified, then either a screen and/or email/text message alarm will appear.